Clarifilter CLF-MWF Compatible with GE Smartwater Fridge Filter & More

This is an Clarifilter CLF-MWF fridge filter, which is compatible with a range of GE Smartwater fridges. For a comprehensive list of compatible models, please see the 'What will it fit?' tab. As GE MWF filters are quite uncommon in the UK, this compatible filter is an ideal and effective solution.

NSF/ANSI 42 Excellent Filtration Performance - The advanced filtration technology ensures that this filter removes/reduces chlorine, odour and taste, organic chemicals, suspended particles, as well as other potentially harmful water contaminants in your drinking water. Providing you with clean and healthy water.

WRAS Tested and Approved - The in-depth testing by WRAS ensures that our filter does not impart odour or flavour on the water, ensures the water is free from change in colour or appearance, does not enhance microbial growth or leach harmful substances or metals into the water. WRAS approval means that our filters comply with strict Water Supply Regulations or Scottish Byelaws.

Technical Specifications:

• Flow Rate: 1.9 lpm (0.5 gpm)
• Operating Pressure: Min. 140 kPa (20 psi) / Max. 827 kPa (120 psi)
• Operating Temperature: Min. 0.6 °C (33 °F) / Max. 38 °C (100 °F)
• Capacity: 1,325 litres (350 US gallons)

Installation:

• Slowly turn the old cartridge 1/4 turn to the left (counter clockwise). Note: Do not pull down on the cartridge.
• Remove and discard the old filter (the water will shut off automatically).
• Peel off the protective cover from the new cartridge.
• Fill the new replacement cartridge with cold water to allow for better flow immediately after installation (you can use tap water).
• Line up the arrow on the cartridge with the cartridge holder. Note: Do not force it up into the holder.
• Turn the filter 90 degrees right (clockwise) until the cartridge stops. Do not over tighten.
• Run water through the dispenser for 3 minutes to purge the system.
• Check the filter area for leaks.
• Reset the filter status light by pressing and holding the Reset Water Filter button for 3 seconds.

When to change a filter: The filter cartridge should be replaced when the replacement indicator light turns red, or every 6 months, or if you notice a decrease in the flow of water from the dispenser.

Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. The contaminants or other substances removed or reduced by the water filter device are not necessarily to be found in your water.

It is essential that operation, maintenance and filter replacement be carried out in accordance with manufacturer's recommended procedures and guidelines for this product to perform as advertised. Failure to do so may void warranty.

Important: Install on cold water line only.

Note: This filter also helps reduce lime-scale build-up to protect your refrigerator and ice mak